Photo Gallery

I needed something to keep my calibration loads organzied

Home built Allstar Node on a RaspPi 4B with builtin UPS

My second radio. Bought this to better understand repeaters and offsets. (5 watts)

This was my first official ham radio. It does analog and digital (7 watts)

Second DMR Hotspot I built using a RaspPi 3B+ a homemade 3D printed case. It’s a powerful radio and controller in a slick little package

3D printed the SO-239 holder with some 20 gauge antenna wire

My first HF radio, go big or go home right?

I cut the antenna long so I could trim it into freq. This was the initial reading

This is the final iteration of my 10M Inverted V. 3D printed a new SO-239 holder and she’s peaked at 21ft off the ground

My first dual band 2m-70cm mobile radio that does analog only at 30 watts

This was my second Allstar node running a RaspPi5B that I ordered from KitsForHams

I always keep the second band of my dual band radio on the national simplex frequency

This is my little 5 watt QRP radio. 3D printed the legs and I’m using a Commountain mic

This is my first hotspot. It started life as a simplex node on a RaspPi Zero but soon landed on a RaspPi 3B+